Overview
A manufacturer needed a workholding solution for hard turning both sides of hardened valve seat inserts. The application was extremely demanding, with cutting conditions severe enough that flames could sometimes be seen during the operation. The workholding also needed to accommodate multiple part sizes while maintaining very tight repeatability over long production runs.
Challenge
Hard turning places significant stress on both the part and the workholding, especially when accuracy must be maintained across high volumes.
- Both sides of the hardened valve seat insert had to be machined
- The cutting process generated extreme heat and force
- Multiple part sizes required fast and reliable changeover
- Repeatability needed to remain at 0.0001" T.I.R. or better
- The workholding had to maintain that performance over extended production use
Solution
Northfield supplied a custom system built around the Model DPH-600W, 6-inch Diaphragm Chuck with special quick-change top tooling.
- Custom top tooling was designed specifically for the valve seat application
- Quick-change part stop pads allow different part sizes to be changed efficiently
- The diaphragm chuck provides the precision needed for hard turning both sides of the component
- Because the diaphragm chuck has no sliding internal moving parts, there are fewer components exposed to wear from chips, heat, and repeated cycling
Outcome
The result is a workholding system that has proven itself over many years and countless parts.
- Maintains 0.0001" T.I.R. repeatability or better
- Supports quick changeover between multiple part sizes
- Performs reliably in an extremely aggressive hard-turning environment
- Maintains accuracy over extended production runs
- Delivers long service life because the diaphragm design eliminates internal sliding components that can wear over time
This application highlights why Northfield Diaphragm Chucks are especially well suited for demanding hard-turning operations where precision, durability, and long-term consistency are critical.
Contact [email protected] to discuss your hard-turning or custom workholding application.